Proof Verification with Label
Hard proof verification using the ISO 12647-7 Control Wedge 2013.
Overview
This project is based on the Idealliance ISO 12647-7 Control Wedge 2013 and is designed to demonstrate how users can verify a hard proof and the print certification label. A variety of label sizes is predefined.
You can upload existing measurement data to the project. Alternatively, other control strips, such as the Ugra/Fogra Media Wedge, are also supported for upload.
Instrument Inspector Verification
Check your instrument by measuring it with Instrument Inspector. This test form can be used as a short-term target.
Steps to test Instrument Inspector:
- Create a baseline in scan mode with Instrument A.
- Create another baseline in spot mode with Instrument A.
- Repeat the same steps with instruments B, C, etc.
- Compare baselines of different modes and instruments.
- Remeasure the same target to verify if the instrument is consistent over time.
